| Weather boards
are available in both round and square edge profiles. The
standard weather board profile is 4mm at the tip and 19mm
at the butt. The standard board has an end section measurement
of 175mm wide. Coverage should be calculated at 150mm, allowing
for a 25mm overlap. All weather boards supplied by H.Waterhouse
and son are preservative treated as to prevent rot. Don’t
be fooled by painted or primed weatherboards, painting does
not prevent rot or decay. Please
calculate your requirements before enquiring about price,
this way you will get the best deal! |
|
External claddings
are available in many different profiles, with the most common
being pattern 401 and 402 (tongue and groove) as shown below.
Coverage for these claddings should be calculated at 133mm,
this allows for the overlap in the tongue and groove. If we
do not stock your profile, please enquire about our *special
order service. If we don’t have it, we may be able to
make it.
(*special orders require minimum quantities) |
|
| Linings are
available in many different sizes, with the most common being
the 302 or 321 pattern profiles as shown below. Linings are
typically 12mm in thickness and 140mm in width. Coverage for
these linings should be calculated at 133mm, this allows for
the overlap in the tongue and groove. Linings are available
in treated and untreated forms, for use both externally and
internally. |
|
| Timber fascia
is available in 190 x 32mm end section size and is standard
with two rebates for use with cement sheet under eave installations.
Whilst this is the most common size of fascia used, older
homes may require a different or non standard size fascia,
if you have special requirements, please enquire with our
sales staff about our special order service. All fascia supplied
is preservative treated as to increase its service life. Don’t
be fooled by painted or primed fascia, painting does not prevent
rot or decay. |
|
| Floorings
are available in traditional 140x19mm tongue and groove (calculate
coverage at 133mm) in both treated pine (for wet areas or
external use) and untreated finish for use above ground internally.
Pine flooring is NOT
recommended as a feature
flooring (exposed floor), being a softwood it has a tendency
to mark quite easily, but rather for under additional floor
covering applications. |
H.Waterhouse and Son also stock
yellow tongue particle board flooring, 3.6m x .9m sheets, 19mm
thick. Particle board flooring is typically used in the construction
of new housing or house renovation where the floor will be covered
by a secondary covering. (Tiles carpet ect.). Yellow tongue flooring
is acceptable for use in wet areas also, (bathrooms, kitchens
ect) and as the sheets are quite large, installation costs are
considerably lower than alternative flooring systems.
